Holder for Ryobi RAPID Assembly Driver. Mount to Pegboard, Wall, or Ryobi Link

Description: This holder is uniquely designed to hold a Ryobi RAPID Assembly Driver Model #RHSDM3501 and additional cartridge(s). The driver simply pushes into the hourglass-shaped portion of the holder at the neck of the driver, holding it firmly with a slight pinch. Behind that, there is a slot to hold a bit cartridge. There are also versions that hold at total of 3 or 5 cartridges. It can be mounted in a variety of ways including screws to the wall, pegboard*, and Ryobi Link Wall Rails. It includes 6 pegs: 3 curved and 3 straight if you choose to mount it to pegboard. If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw (not included) to hold it into place. The Ryobi RAPID Driver Model #RHSDM3501 and Cartridge(s) are NOT included and shown in photos for reference only. * Note that there are many different types of pegboard and some may not work. This is designed to work on 1/8" thick masonite pegboard with holes at 1" (25.4mm) on center only. Dimensions:1-cartridge - 2.4" x 3.0" x 3.5" (59mm x 76mm x 90mm)3-cartridge - 4.9" x 3.0" x 3.5" (125mm x 76mm x 90mm)5-cartridge - 4.9" x 4.0" x 3.5" (125mm x 101mm x 90mm) This is uniquely designed and 3D-printed by the Seller in the USA. Items are lightweight and 3D-printed in PLA plastic. Due to the printing process, there may be some minor imperfections which are mostly likely to be on the bottom/back side, not exposed to view. PLA plastic is made from a renewable resource and is biodegradable and eco-friendly. 3D Printing involves the heating and depositing of material on a flat board one layer at a time, thus most exposed sides have small, fine lines. Infill (non-exposed) areas are not solid plastic.

Price: 10.95 USD

Location: Lexington, Kentucky

End Time: 2024-09-05T15:49:41.000Z

Shipping Cost: 0 USD