[3DMakerworld] Adafruit ADS1115 16-Bit ADC - 4-Channel

Description: Key Features: Provides 16-bit precision at 860 samples/second over I2C Great general purpose 16 bit converter Can be configured as 4 single-ended input channels, or two differential channels Up to 4 ADS1015s connected on a single 2-wire I2C bus for 16 single ended inputs possible For microcontrollers without an analog-to-digital converter or when you want a higher-precision ADC, the ADS1115 provides 16-bit precision at 860 samples/second over I2C. The chip can be configured as 4 single-ended input channels, or two differential channels. As a nice bonus, it even includes a programmable gain amplifier, up to x16, to help boost up smaller single/differential signals to the full range. We like this ADC because it can run from 2V to 5V power/logic, can measure a large range of signals and its super easy to use. It is a great general purpose 16 bit converter. The chips fairly small so it comes on a breakout board with ferrites to keep the AVDD and AGND quiet. Interfacing is done via I2C. The address can be changed to one of four options (see the datasheet table 5) so you can have up to 4 ADS1115s connected on a single 2-wire I2C bus for 16 single ended inputs. To get you started, get example code for the Raspberry Pi, Arduino and CircuitPython. Simply connect GND to ground, VDD to your logic power supply, and SCL/SDA to your microcontrollers I2C port and run the example code to start reading data. Item Specifics Supply range: 2.0V to 5.5V Current Consumption: Continuous Mode: Only 150µA Single-Shot Mode: Auto Shut-Down Programable data rate: 8SPS to 860SPS Internal Low-Drift Voltage Reference, Oscillator, and PGA I2C INTERFACE: Pin-Selectable Addresses Four Single-Ended OR Two Differential Inputs Programable Comparator This board/chip uses I2C 7-bit addresses between 0x48-0x4B, selectable with jumpers

Price: 23.09 USD

Location: Lenexa, Kansas

End Time: 2024-11-29T16:43:28.000Z

Shipping Cost: N/A USD